Features of reinforcing and repairing building structures after prolonged exposure to moisture
DOI:
https://doi.org/10.26906/znp.2026.66.4672Keywords:
brick wall, soil, soaking, moisture meterAbstract
Inspections of buildings and structures are conducted to obtain objective data on the actual condition of building structures, taking into account changes over time. The effect of moisture on structures in contact with the ground leads to a decrease in performance and a loss of strength. At a specific major renovation site, a study was conducted on the condition of brick structures that were subject to constant wetting due to leaks in water supply networks. The condition of the brick structures in contact with the ground, as revealed during demolition work, was found to be worse than that determined by visual inspection. The article presents structural solutions for the restoration of building elements that allow for a reduction in their moisture content over the long term.
References
1. Asphaug, S., Hjermann, I., Time, B., & Kvande, T. (2020). Moisture control strategies of habitable basements in cold climates. Building and Environment, 169, 106572. https://doi.org/10.1016/j.buildenv.2019.106572
2. Asphaug, S., Hjermann, I., Time, B., & Kvande, T. (2022). Monitoring outward drying of externally insulated basement walls: A laboratory experiment. Building and Environment, 219, 109097. https://doi.org/10.1016/j.buildenv.2022.109097
3. Szemiot, N., Hoła, A., & Sadowski, Ł. (2022). Assessment of the effectiveness of secondary anti-damp insulation in limit state design approach for hybrid reinforced concrete column-supported flat slabs. Structural Concrete, 23(6), 3444–3464. https://doi.org/10.1002/suco.202100785
4. Brzyski, P., Barnat-Hunek, D., Suchorab, Z., & Łagód, G. (2023). Moisture in heritage buildings made of historic brick: The current state of knowledge, research gaps and perspectives. Heritage Science, 11, 198. https://doi.org/10.1186/s40494-023-01043-x
5. Xue, Y., Fan, Y., Lu, J., & Ge, J. (2022). The moisture distribution in wall-to-floor thermal bridges and its influence on mould growth. UCL Open: Environment, 4, Article 13. https://doi.org/10.14324/111.444/ucloe.000042
Downloads
Published
Issue
Section
License
Copyright (c) 2026 Andriі Filonenko
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
